iopgroup.blogg.se - Demon Drivers Capsule

#Demon Drivers Capsule serial number#
#Demon Drivers Capsule install#
#Demon Drivers Capsule serial#
#Demon Drivers Capsule full#

The ABL intends to approach the WNBA next week, proposing a game be played perhaps in the fall after the WNBA season ends and ABL teams are in training camp. ABL co-founder Gary Cavalli issued what he called a friendly invitation to WNBA officials to explore the idea of a game between all-stars of the two leagues. It was the first time Chamberlain had been back since 1975, and his only official appearance since he turned pro in 1958 following a bitter triple-overtime loss to North Carolina in the NCAA title game his junior year.

Try removing the Demon from the ECU.Wilt Chamberlain, ending a mysterious 40-year separation from the school where his basketball career took off, brought an overflow crowd to its feet when Kansas retired his No.

No lights at all when USB is plugged in generally is a fault condition.

Red on / green off is expected with no power.

Green light off means no power to ECU.

This is REQUIRED for proper Demon operation

Check ECU CN2 – 4 pin port connection.

Check 28 pin socket bridge pins and connection.

You will only see this condition when the Demon is being powered by USB.

Red light onwith USB plugged in means the Demon is NOT receiving power from the ECU.

Fast green blinks mean the Demon is receiving good datalogging packets from the ECU.

Green light is off when the device is busy OR Demon is powered off.

Solid green light when the Demon is powered on and all systems are go but no packets are being received.

Red LED will blink when logging packets are being captured.

Red light on solid = not receiving power from the ECU: physical connection issue to ECU.

The red LED serves as a hardware status indicator and/or busy light. Light behavior has been changed in the new firmware. Indicator Lights (1.9 and newer firmware)

Slow blinking likely means data timeout / incorrect connection/configuration.

Fast blinking means data is flowing properly from ECU to Demon via CN2.

Blinks when the Demon is communicating with the ECU (assuming data packets are configured correctly).

Lights up solid green when the Demon is powered on.

The green LED is more of a data packet and status indicator light.

Red LED will blink when onboard packets are being stored to memory.

#Demon Drivers Capsule serial#

NEPTUNE RTP ONLY: No serial communication between ECU and Demon.Demon is powered via USB but there is no power to ECU.(usual cause: cabling, cable backwards, faulty installation) Poor / nonexistent connection between Demon and ECU CN2 port.Poor / nonexistent connection between Demon and ECU 28 pin socket.Demon is currently processing a command (upload/download/etc).The Demon has two LEDs to indicate its status, one red and one green. Indicator Lights (1.8 and older firmware) You can now more easily switch among the different applications using our Config Utility for resetting the state of your Demon. You’ll have to send your Demon back to us – turnaround time is normally about 2 weeks.

#Demon Drivers Capsule install#

If you are interested in this service, purchase the Install Service item and note in the “Comments” field of your order that you would like the Demon memory upgrade. Early production units can have their memory upgraded. Current (starting around April 2010) production units have 4Mbyte memory. The first production runs of Demons have 1 Mbyte memory for storing datalogging. The exact procedure for this is different for each software package.

#Demon Drivers Capsule serial number#

Please note that each Demon has a serial number – NepTune and eCtune both license a single copy of the software to a single Demon.

#Demon Drivers Capsule full#

Neptune: Full emulation+data+onboard (release) As of 11/03/09 software support is as follows: